There are 16 virtual devices available. There are mainly two reasons leading to a similar malfunction: This explains why you think that you can read the EEPROM of the second , but not see any response or changes in the measurements. In the user interface you will find a device selector device If you cannot solve the problem, please send us Melexis or your local rep some raw data to analyze.
|Date Added:||19 February 2014|
|File Size:||50.11 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
PTC-04 – Programmer for Melexis PTC devices
In all other cases I do not know any reason why you can not reprogram the device. This explains why you think that you can read the EEPROM of the second pfc-04, but not see any response or changes in the measurements. I need imformation about these methods and meexis. It means that the actual angle where this happens can be at 50 Degrees or Degrees However, by using the multi point end-user calibration, this error can be improved.
If the calibration due date is exceeded, a warning message is given.
PTC Programmer | Melexis
If it is connected directly or through a relay, the programming should be the same. An IBM compatible PC is required not included to load software to the programmer and control the functions of the programmer.
Is it meleixs to tell what sensors I actually received with the PTC? Melexis offers the option of performing a trimming and forming of the leads in order to get a device suitable for SMD mounting.
I use a safety-critical sensor with dual MLX The values I receive are wrong. You can download the software from softdist. Creating a complex programming protocol compared to a simple mathematical calulation will take much more resources and create more errors.
Otherwise you need the Prc-04 programmer.
Furthermore, the programming protocol is based on “exotic” waveforms on the supply line up to 15 V and the output line. But when click mepexis “characterize” button, an error dialog turns out: Setting Vdd to 0 V first could help. HLP for more details. Based on your explanation you already succeeded in programming the device. The IC is mlxkgo. Check the connections of Vdd, Gnd and output.
It is not possible to program them in one step. Also, you can order pre-programmed part in analog mode, but on degrees from ptd-04. Question It’s for a real application in a lab: If it matches then the problem is solved. Because in doc there is no info obout.
In such a case you have to upload the correct firmware: If you use an external 5V power supply, then you can connect the scope to the output pin pin5 for SO8 and check the changes.